Elinchrom Ranger RX Speed 1100ws (unit only).
The upgraded Ranger RX unit, plus the new Speed and Speed AS units are designated RX because
they may be operated by remote control by computer or by a handset enormously increasing the
ease of use on location.
The basic unit has an improved fast recycling sequence and the Speed unit will recycle to full
power in 2.9 seconds plus up to 250 flashes.
The Speed unit is available with either 2:1 asymmetrical or symmetrical output.
It incorporates the most advanced miniaturised components weighing in at only 8 Kg, much lighter
and smaller than any comparable unit.
The same modified circuitry has permitted an extension of its power range to 7 f-stop, with
enhanced stability. We believe these will be the units to which others will be compared.
This fast unit will be delivered with:
1x Shoulder Strap
1x Battery Box (incl. Battery)
1x Synchro Cord
1x Quick Charger (240V only)
Characteristics:
-Consistent flash power at any battery level.
-Guide number all units max. power-f-64.1 @ 2 m distance 100 ISO
-Charger, Multi-voltage with European, USA and UK adapters.
-Battery re-charging - to full power- 3 hours.
-The charger can charge the battery in the unit or externally.
-Power saving, auto cut off of modelling lamp and charging
-Modelling Lamp modes, 15 s, 30 s & off
-Photocell, adapted to release in bright ambient light.
-Charge Ready Beep, on/off, with green LED indicator.
-Charge Ready Light / Open Flash, indicated with bright LED!
-Auto Dump Function, adjust power levels after setting automatically
-Battery Charge Indicator, two green LED 100%, one green LED 50%, one red LED
approx. 10%. The Ranger electronic protects the battery from over and complete discharging.
The battery can be recharged at any level. There is no Memory-Effect!
-Battery-Box Quick Release, to release, press the two push buttons at the left and right
side of the housing, lift up the unit releasing the existing battery - then place the pack
over the replacement battery, pressing firmly down for automatic locking.
-Moisture resistant rubber protectors.
-Raised sockets complete with covers; electronics only in the upper part of the unit.
|
